Multiple causes for printing gaps on U.S. stamps
U.S. Stamp Notes by John M. Hotchner
Gaps in printing such as on the examples shown with this column can have many causes. I will discuss some of them here.
Printing gaps are not errors in the sense that stamp catalog editors use that term. They are fairly minor artifacts of the printing process, and even if they repeat, each example is likely to be just a bit different from any other. Still they are interesting examples of what can go wrong with the ever more complicated printing presses used to produce United States stamps.
Our first example is the 29¢ Flag Over White House stamp of 1992 (Scott 2609) shown in Figure 1 with a graphically cropped close-up of the blank area on the flag’s field of stars in Figure 2. The most authoritative explanation for such events is what the printer has to say about them, and we are lucky in this case to have the Bureau of Engraving and Printing’s thoughts in the form of a letter dated June 3, 1995:
“… a white spot exists, approximately off-center, in the field of stars on the flag. … Our examination staff has determined that except for the white spot, the stamp has the full complement of intaglio printing and full coverage of phosphor taggant.
“The white spot was examined carefully with stereobinocular and compound microscopes, and only minute traces of blue ink were detected. This examination also revealed that no fibers were lifted and there was no evidence of embossing from engraving on the printing cylinder.
“An examination with another microscope which is used for the examination of surface profiles indicates that the area in the white spot is slightly depressed and is rougher than other areas of unprinted paper on the stamp. This examination indicates that the area of the white spot was never in direct contact with a corresponding area on the printing cylinder.
“There are two possibilities for the existence of the white spot. One is that there was an indenture in the impression cylinder of the printing press. An indenture in the printing cylinder would have resulted in more ink included in the area of the white spot because of inadequate wiping, since an indenture essentially creates another engraving.
“The other possibility is that a foreign object, such as a fragment of paper, was present on the paper web during the instant in which the image of the stamp was printed and this prevented ink from being deposited on the paper in the area of the white spot.
“The foreign object may then have transferred to the printing cylinder, or fallen off the paper web prior to the application of phosphor taggant. Therefore the presence of a foreign object is a more likely cause of the white spot on the stamp.
“The stamp, somehow, escaped detection during examination and should have been destined for destruction since it does not meet Bureau of Engraving and Printing quality standards.”
To read the entire U.S. Stamp Notes column about printing gaps on U.S. stamps, subscribe to Linn’s Stamp News.
Connect with Linn’s Stamp News:
MORE RELATED ARTICLES
US StampsOct 14, 2021, 6 PM
World StampsOct 14, 2021, 12 PM
World StampsOct 13, 2021, 7 PM
Postal UpdatesOct 13, 2021, 2 PM